5
TRUE
tcgr
www
.truemfg.com
LOCATING
A. Use a Phillips screw diver and remove four screws from the
L-bracket connected the unit to the wood skid (image 1).
Then use a 3/8" (9.5 mm) socket or wrench and remove the
L-bracket from the unit (image 2).
TO AVOID DAMAGE TO GLASS DO NOT LAY
CABINET ON ITS SIDE OR BACK WHEN REMOVING
SKID, INSTALLING LEG LEVELERS, CLEANING, ETC.
B. Lift up from the base and walk unit off the skid and set in final
location.
C. Unblock doors, free plastic wedges, blue foam and tape.
Remove fiberglass tape securing glass. Remove components:
(shelves, brackets, etc.) from inside cabinet.
D. Applicance tested according to the climate classes 5 and 7 for
temperature and relative humidity.
LEVELING
A. Set unit in its final location. Be sure there is adequate ventilation
in your room. Under extreme heat conditions, (100°F+,
38°C+), you may want to install an exhaust fan.
WARNING: WARRANTY IS VOID IF VENTILATION IS
INSUFFICIENT.
B. Proper leveling of your TRUE unit is critical to operating success
(for non-mobile models). Effective condensate removal and
door operation will be effected by leveling.
WARNING: DISPLAY CASE MUST BE LEVELED
ACCURATELY TO ENSURE FRONT GLASS DOOR
SEALS PROPERLY.
C. The unit should be leveled front to back and side to side with
a level. Place the level in the interior floor of the unit and check
all four sides.
D. If the cabinet is not level adjust leg levelers by first relieving
weight to leveler and adjusting by either hand or wrench.
Repeat with all leg levelers until cabinet is level in all directions.
E. Ensure that the drain hose or hoses are positioned in the pan.
F. Models with power cord: Free plug and cord from inside the
lower rear of the cooler (do not plug in).
G. Models with power cord: The unit should be placed close
enough to the electrical supply so that extension cords are
never used.
WARNING: CABINET WARRANTIES ARE VOID IF OEM
POWER CORD IS TAMPERED WITH. TRUE WILL NOT
WARRANTY ANY UNITS THAT ARE CONNECTED TO
AN EXTENSION CORD.
RECOMMENDED OPERATION CONDITIONS (75˚F
DEGREES & 55% RELATIVE HUMIDITY)
WARNING: DRY BAKERY CASES REQUIRE HARD
WIRING UNLESS ORDERED WITH 12" (30.5 CM)
CORD OPTION. CABINET WARRANTIES ARE VOID
IF OEM POWER CORD IS TAMPERED WITH. TRUE
WILL NOT WARRANTY ANY UNITS THAT ARE
CONNECTED TO AN EXTENSION CORD.
Removing bracket from skid. Removing bracket from cabinet.
1 2
To Next Page
Loading...
