9
10. UPDATING THE FIRMWARE
For the latest firmware containing the most up-to-date speed camera database, visit the TrueCam web-
site (truecam.com/downloads).
UPDATE PROCEDURE:
A
Prepare a microSD card by formatting it on a PC / Mac.
B
Download and open the .zip file with update files. Do not change the files‘ names.
C
Copy and paste ALL the files to the formatted microSD card.
D
Insert the MicroSD card into the SWITCHED-OFF camera.
E
IMPORTANT! Press and hold the WiFi button on the dashcam before plugging in the dashcam
into the power supply. Hold the button after turning on the dashcam for at least 15 seconds,
the red LED light will start blinking very fast (= updating sequence has started).
F
It takes approximately 2 minutes to install the new firmware. You will know when the installation is
successfully completed by the sound of the welcome tone.
G
Then format the memory card directly in the camera (by holding the WiFi button for 10s).
11. INSTALLING THE REAR CAMERA (OPTIONAL)
A
The ideal location for the rear camera is the upper center part of the rear window.
B
Make sure that the glass is clean and dry at the attachment point.
C
Remove the film from 3M adhesive pad on the camera holder.
D
Before attaching it to the glass, point the camera to capture best view.
E
Press the 3M adhesive pad onto the glass and hold it for a while.
F
Connect the rear camera to the switched off front camera with the connecting cable. Guide it side-
ways to the passenger side and gradually push the cable under the upholstery using the tool.
12. PRECAUTIONS AND NOTICES
PRECAUTIONS AND NOTICES
›
For your own safety, do not use the camera’s controls while driving.
›
A window mount is needed when using the recorder in a car. Make sure that you place the recorder
in an appropriate place, so as not to obstruct the driver’s view or deployment of airbags.
›
Make sure that no object is blocking the camera lens and no reflective material is placed near the
lens. Please keep the lens clean.
›
If the car windscreen is tinted or heated, it may limit the quality of the recording and, above all, the
GPS signal.
›
For general use it is recommended to have motion detection disabled. It may lead to the memory
card filling up quickly.
›
The camera is primarily designed to operate while being constantly connected to a power supply.
›
Make sure that the legislation of the country where you operate the vehicle allows the use of
dashcams and speed radar alerts.
SAFETY PRECAUTIONS
›
Use only the charger supplied with your device. Use of another type of charger may result in
malfunction and/or danger.
›
Do not use the charger in high moister environment. Never touch the charger when your hands or
feet are wet.
›
Allow adequate ventilation around the charger when using it to operate the device or to charge the
battery. Do not cover the charger with paper or other objects that will reduce cooling. Do not use
the charger while it is inside a carrying case.
›
Connect the charger to a proper power source. The voltage requirements are found on the product
case and/or on the packaging.
To Next Page
Loading...
