8
10. comPlete settinGs
settinGs descriPtion
Resolution Sets the video / photo resolution
Higher resolution = more detail and larger file
60 fps = 60 frames per second = smoother video
Loop recording Sets the length of each loop
Longer loop = larger file
Loop recording can also be turned off and recording will end if the SD
card is full
WDR When turned on, the camera compensates for luminance when there
are very bright and very dark areas in the picture
Brightness Sets the overall brightness of the recording
At the same time, the camera automatically adjusts the brightness of
the recording depending on the light
Motion detection Turns motion detection on / off
More about this feature in Section 6
Parking mode Turns parking mode on / off
More about this feature in Section 6
Record audio Turns the microphone on / off
Also possible to switch by holding down the MENU / MODE button
while recording
G-Sensor sensitivity Sets the sensitivity of the G-Sensor
More about this feature in Section 6
Date stamp Displays time and date in video
WiFi Turns WiFi on / off
Date / time Sets date and time
Hold OK / POWER button = confirm
Hold MENU / MODE = cancel
The time and date are set automatically when pairing a camera with a
smart device via WiFi
Driver name Sets the text in the video
Hold OK / POWER button = confirm
Hold MENU / MODE = cancel
Screensaver The camera continues to record during screen saver
Press any key to exit the screen saver
Volume Adjusts the volume of all camera sounds
System sounds Turns sound on / off for buttons and on / off status
Language Sets the camera menu language
Format Formats data on memory card
Default settings Sets camera to factory settings
Firmware version Displays the installed FW version
To Next Page
Loading...
