X
X
L
L
D
D
C
C
M
M
A
A
N
N
.
.
d
d
o
o
c
c
3
3
-
-
2
2
6
6
R
R
E
E
V
V
E
E
To determine or modify the present position, press "FUNC/ENTR", "5","6" and the display will show:
Averager Count or Entered Average
XXXXX/90000 Position
indicating either that the present average position is based on XXXXX position fixes, and that 90000
such fixes will be averaged to complete the accurate position determination or that the current
averaged position was entered. Press "FUNC/ENTR" again to display:
Ave. Latitude
N DD MM'SS.S"
By pressing a combination of arrow keys and/or direct digit entry, this latitude may be changed. When
the latitude value is as desired, press "FUNC/ENTR" to display:
Ave. Longitude
W DDD MM'SS.S"
By pressing a combination of arrow keys and/or direct digit entry, this longitude may be changed.
When the longitude value is as desired, press "FUNC/ENTR" to display:
Ave. Altitude
+XXXXXX Meters
By pressing a combination of arrow keys and/or direct digit entry, this height above the WGS-84
ellipsoid may be changed. When the height is as desired, press "FUNC/ENTR" to display:
Enter average
position? No
This choice will only be made available if the XL-DC is operating in the TIME mode. Use the up or
down arrow key to toggle to the desired response and press "FUNC/ENTR" to either cancel entry or
complete it.
3-157 through 3-159 reserved
3-160 KEYPAD FUNCTION 60 - SATELLITES LIST REQUEST
Use Function 60 to list tracked or bad satellites and to see the relative signal strength of the tracked
satellites.
Press "FUNC/ENTR", then "6", "0". The display will show:
List sats:
Tracked
Press the up or down arrow keys to toggle between "Tracked" and "Bad". Once the type of list has
been selected, press "FUNC/ENTR" again. The display will show:
Tracked Sats: or Bad Sats:
#14 +13.65 #14
To Next Page
Loading...