X
X
L
L
D
D
C
C
M
M
A
A
N
N
.
.
d
d
o
o
c
c
3
3
-
-
2
2
7
7
R
R
E
E
V
V
E
E
depending on which list was requested. Some other satellite number may display. When observing
Tracked Sats the number following the satellite number is the relative signal strength of that satellite.
Each time "FUNC/ENTR" is pressed the display will show the next Tracked or Bad Satellite number.
When the list is complete the display will show:
Tracked sats: or Bad sats:
End of list End of list
Press "FUNC/ENTR" again and the display will show the initial display. Press the "STATUS" button to
exit Function 60.
3-161 through 3-164 reserved
3-165 KEYPAD FUNCTION 65 - SATELLITE SELECT
Use Function 65 to select specific satellites for the receiver to track and to deselect satellites, i.e.,
instruct the XL-DC to ignore certain satellites. Selections will be retained in non-volatile memory. Press
"FUNC/ENTR", then "6" "5". The display will show:
Sat# 14 or Sat# 14
Enabled D
isabled
or some other satellite number. Press the up or down arrow key to toggle between "Enable" and
"Disable". When the display shows the desired choice press "FUNC/ENTR". Each time "FUNC/ENTR"
is pressed, the display will show the next satellite and whether it is enabled or disabled until all satellites
for which the GPS core receiver has data are displayed. Then the display will show:
End Press
Enter to confirm
Press "FUNC/ENTR" to enter your selections. To abort without changing the status of the satellites
press the "STATUS" button.
3-166 KEYPAD FUNCTION 66 - DAYLIGHT SAVING ENABLE
Use Function 66 to set the Daylight Saving Time entry and exit times. The as-shipped default is "Off".
The default on power-up will be the selection in use just prior to power-down.
Press "FUNC/ENTR", then "6" "6". The display will show:
Daylight Saving or Daylight Saving
Off M
anual
Press the up- or down-arrow key to scroll between the choices. When the display shows the desired
choice, press "FUNC/ENTR" to enter your choice.
To Next Page
Loading...