www.deluxegroup.co.nz
Start-up
The interior can be heated in gas, electrical or mixed mode, either with or without water, depending
on the setting. Check whether the power supply fuse protection at the camp site is adequate for the
900 W (3.9 A) or 1800 W
(7.8 A) that have been selected using the power selector switch.
The cable drum must be fully unwound in order to prevent the power cable from
overheating.
– Check to make sure the cowl is unobstructed. Be sure to remove any covers that may be present.
– Open the gas cylinder and the quick-acting valve in the gas supply line.
– Fill boiler with water if necessary (see “Filling the boiler”).
– Switch on the unit on the control panel.
Switching off
– Switch the heater off on the control panel.
– The switch-off procedure may be delayed by several minutes because of internal heater
operations.
Always drain water contents if there is a risk of frost!
If the appliance is not used for a long period, close the quickacting valve in the gas supply line and
the gas cylinder.
Maintenance
Only original Truma parts may be used for maintenance and repair work.
– Clean the compartment where the unit is installed at least once annually.
– Have an expert check the unit for dirt and clean it if necessary.
– The safety/drain valve must be operated regularly (at least twice annually) to remove limescale
deposits and to be certain that it is not blocked.
We recommend the use of suitable commercially available products to clean, sterilise and maintain
the boiler. Products containing chlorine are not suitable.
The effectiveness of the use of chemicals to combat microorganisms in the appliance can be
increased by heating the water in the boiler to 70 °C at regular intervals.
– Select “Gas mode”. – Set the water temperature to 60 °C.
– Switch on the appliance.
To Next Page
Loading...
