Truma Combi 6E - Maintenance and Functionality; Function Description Combi E

www.deluxegroup.co.nz
– Danger of fire / explosion if you attempt to use a Combi that has been damaged by flooding or if
the vehicle has been involved in an accident. A damaged Combi must be repaired by an expert or be
replaced.
– Have faults repaired by an expert without delay.
– Only carry out repairs yourself if the solution is described in the
troubleshooting guide of this manual.
– Following a deflagration (backfire), have the appliance and the exhaust duct
checked by an expert.
Maintenance / Repairs / Cleaning
– The unit may only be repaired and cleaned by an expert.
– Maintenance, repairs and cleaning must not be done by children.
– Guarantee claims, warranty claims and acceptance of liability will be ruled out in the event of the
following:
– Modifications to the appliance (including accessories),
– Modifications to the exhaust duct and the cowl,
– Use of replacement and accessory parts other than original Truma parts,
– Failure to follow the installation and operating instructions. The appliance’s operating permit, and
consequently also the vehicle’s operating permit in some countries, are also rendered void.
– With a new Combi or if the appliance has not been used for some time, thoroughly rinse all
hot/cold water hoses with drinking water before use.
Function description (Combi E)
The liquid gas heater Combi E is a warm-air heater with integrated hot water boiler (10 litres
volume). The burner is fanassisted, which ensures that operation is problem-free, even when on the
move. The unit also has heating elements for electrical operation.
In heating and hot water mode the heater can be used to heat the room and heat water up at the
same time. If only hot water is required, select hot water mode.
At a temperature of approximately 3 °C at the automatic FrostControl safety/drain valve, the valve
will open and drain the boiler.
3 different options are available for operating the unit:
– gas mode only Propane / Butane for autonomous use
– electrical mode only 230 V for stationary use on camp sites