Truma MonoControl - Page 27

27EN
8
6
Figure 3
– Check for leaks (e.g in Germany in accordance with G 607).
– If there is a gas system leak, close the cylinder valve, have the gas
system repaired by an expert immediately and do not open the
valve in the meantime.
– Unscrew the pump from the test connection and screw the
screw cap (8) back onto the test connection.
– It is essential to reattach the screw cap (8) every time after it has
been removed.
– Reset the reset button.
To reset, press the reset button (6) firmly and turn it slightly anticlock-
wise. Ensure that the reset button (6) remains in the position “ready
for operation” (Figure2a).
The Torx T20(10) from the screw aid(9) can be used to assist
the turning movement.