10 EN
supervised or have been instructed in the
safe use of the appliance and understand the
resulting risks. Children must not be allowed
to play with the appliance.
– The Therme is designed for pressure-free
operation. In order to enable the pressure,
which builds up during the heating up proce-
dure, to escape, there is to be no non-return
valve installed in the cold water supply (1)
between Therme and submergible pump.
– When connecting to a central water supply
(city mains) or when using stronger pumps,
a pressure reduction valve must always be
installed to prevent that pressures above
1.2 bar develop in the Therme. In addition, a
safety/drain valve (accessory, part no. 70141-
10) must be installed into the cold water
supply line (1).
– Materials in the device which come into
contact with water are suitable for use with
drinking water (see manufacturer decla-
ration: www.truma.com – Manufacturer
Declaration).
Filling the Therme with water
Turn draining and ventilating valves (4) to full extent to close.
With pre-mixing valve
Turn control knob (2) of pre-mixing valve to stop on red
symbol (hot).
With pre-selecting mixing tap(s)
Open hot water tap with pre-selecting mixing taps or set
single lever mixer to “hot”.
Leave the tap(s) open to let air escape and let the Therme fill
up with water until water flows out of the tap.
Electrical operation
Switch the switch (3) on the control panel to “on”. The indica-
tor lamp indicates that the appliance is switched on. The wa-
ter temperature is regulated at 65 °C by the thermostat.
Therme
230 V ~
3
When using the vehicle switches: refer to operating instruc-
tions of the vehicle manufacturer.
Operating instructions
To Next Page
Loading...
