No display of
SPEED figure
1.Check for damaged computer cables then reconnect the lower, upper and
console cables found on page 5 and 10 of the assembly section.
2.Check the Speed SENSOR cable for damage and reconnect to the lower board.
Check the speed sensor and speed sensor magnet for proper positioning.
Recovery function
does not readout
1.Verify the console is in the STOP mode and is not in a program.
2.Verify the pulse readout is functioning.
1.Check slider tubes for damage
2.Clean slider tubes with liquid silicone
3.Check pedal arm wheels for damage.
4.Clean pedal arm wheels with mild detergent and lubricate with liquid silicone
1.Disassemble lower handle bars and check for damage.
2.Lubricate the axis joint with white lithium grease and reassemble.
To Next Page
Loading...