Unplug the machine from the power source for 10 seconds. Plug the machine
back in retest the computer.
Computer will not
power up
1. Plug the power adaptor in to the wall outlet
2. Plug the power adaptor jack in to the unit.
3. Test the wall outlet for power.
4. Test the power adaptor for the correct voltage output.
5. Check the power adaptor and adaptor wire for damage.
6. Check for damaged computer cables then reconnect the lower, upper and
console cables found on page 5 and 10 of the assembly section.
No resistance level
change
1.When the resistance level is changed does the motor run?
Yes
2.Check for damaged computer cables then reconnect the lower, upper and
console cables found on page 5 and 10 of the assembly section.
3. Retest resistance
NO Hand pulse
figure display
1. Reposition hands on the pulse grip Do not hold one pulse grip with 2 hands.
2. Reconnect the pulse grip wire inside the pulse grip handle
3. Reactivate the computer
1. E-1 Indicates the computer was not able to calculate the body fat., Reposition
hands on the pulse grip. Do not hold one pulse grip with 2 hands.
1. E-4 indicates the user’s age, height, weight values have exceed of the
maximum setting range when entering the user information. Reenter values that
do not exceed the maximum values.
1. Check for damaged computer cables then reconnect the lower, upper and
console cables found on page 5 and 10 of the assembly section.
2. Check the Motor and resistance cable for proper positioning.
1.Check the console together with the stage’s 9or12PIN connect cable, to see if
the console are bad contact or get loose with the stage’s 9or12PIN connect
cable.
2. Check the Motor distance have exceed of the setting range or not.
To Next Page
Loading...