TSC MB341T - Page 58

54
Item
Description
Default
Density
Set the printing darkness. Available setting range: 0 to 30.
16
Print Speed
Set the print speed. Available setting range is 1 to 10 for 203dpi and 1 to 7 for 300dpi.
203 dpi: 5
300 dpi: 3
Tear Off
Adjust media stop location. Available setting value range: -120 to 120 dots.
0 dot
Print mode
Set the print mode. There are 4 modes:
 Tear Off: Next label top of form is aligned to the printhead heating line location.
 Peeler Off: Enable the label peel off mode.
 Cutter: Enable the label cutter mode
 Rewind: Enable the label rewind mode
Tear Off
Print Width
Set the print width. Available setting range: 2 to 999 dots.
812 dot
List Fonts
Print the current fonts list from the memory devices to the label.
N/A
List Images
Print current printer available images list stored at the memory device to the label.
N/A
List Formats
Print current printer available formats list from the memory devices to the label.
N/A
List Setup
Print current printer configuration to the label.
N/A
Control Prefix
Set control prefix character.
N/A
Format Prefix
Set format prefix character.
N/A
Delimiter Char
Set delimiter character.
N/A
Media Power Up
Set the action of the media when turning on the printer.
 Feed: Printer will advance one label.
 Calibration: Printer will make calibration.
 Length: Printer determine length and feed label.
 No Motion: Printer will not move media.
No Motion
Head Close
Set the action of the media when closing the printhead.
 Feed: Printer will advance one label.
 Calibration: Printer will make calibration.
 Length: Printer determine length and feed label.
 No Motion: Printer will not move media.
No Motion
Label Top
Adjust print position vertically on the label. Value range: -120 to +120 dots.
0 dot