TSC MB341T - Page 79

75
Problem
Possible Cause
Recovery Procedure
◼ Initialize the printer.
Ribbon encoder sensor doesn’t work
◼ The ribbon encoder sensor connector is loose.
◼ Fasten the connector.
Ribbon end sensor doesn’t work
◼ The connector is loose.
◼ The ribbon sensor hole is covered with dust.
◼ Check the connector.
◼ Clear the dust in the sensor hole by the blower.
Cutter is not working
◼ The connector is loose.
◼ The print mode setting is incorrect.
◼ Plug in the connect cable correctly.
◼ Set the print mode to Cutter Mode