Wrinkle happens from label lower left to upper right direction
◼ Make sure the Printhead Pressure Adjustment Knob is in correct position for the current media. Ex: 1” to 2”, 3” to 4”
◼ Turn the screw counterclockwise per level and print to see if the winkle has gone.
◼ If the ribbon tension adjustment knob has positioned on the level of outermost side but the ribbon slack cannot be removed,
please switch the printhead pressure at 1 level and print the label again to check if the wrinkle is gone.
◼ If the wrinkle can’t be avoided, please contact the Customer Service Department of your purchased reseller or distributor for
service.
To Next Page
Loading...
