How to fix poor print quality on TSC Prontronix TTP-244CE?
To resolve poor print quality on your TSC Barcode Reader: * Ensure the top cover is completely closed and both levers are properly latched. * Verify the power supply provides a 24V DC output. * Reload the supply correctly. * Clean the print head if dust or adhesives have accumulated.
What to do if TSC Prontronix TTP-244CE is not printing?
If your TSC Barcode Reader is not printing, try the following: * Ensure the interface cable is securely connected. * If using a serial port, replace the cable with one that is pin-to-pin connected. * Reset the serial port settings to ensure consistency between the host and printer. * Select the correct printer port in the Windows driver. * Properly configure the Ethernet IP, subnet mask, and gateway.
Why is there no print on the label from TSC Prontronix TTP-244CE?
If your TSC Barcode Reader shows no print on the label, ensure the label is loaded correctly by following the media loading instructions.
How to troubleshoot no response on TSC Barcode Reader?
To troubleshoot a TSC Barcode Reader with no response: * Turn on the power switch. * Check if the green LED is lit on the power supply. If it's not lit, the power supply is likely broken. * Ensure both power connections (from the cord to the supply and from the supply to the printer) are securely connected.
How to stop continuous feeding labels on TSC Prontronix TTP-244CE Barcode Reader?
To address continuous feeding labels on your TSC Barcode Reader, initialize the printer and perform gap/black mark calibration.
What to do if TSC Prontronix TTP-244CE Barcode Reader has paper jam?
To resolve a paper jam in your TSC Barcode Reader: * Calibrate the gap/black mark sensor. * Ensure the label size is correctly set in your labeling software or program to match the installed paper. * Remove any labels stuck inside the printer mechanism near the sensor area.
Step-by-step instructions for placing the printer and connecting it to a computer via USB.
Details how to access basic functions like sensor calibration and factory default via power-on sequences.
Instructions for configuring the printer's Ethernet connection and IP settings via TSC Console.
Overview of available printer functions within the TSC Console, like calibration and test pages.
Procedure to configure post-print actions such as cutter, peeler, or rewinder based on user application.
Diagnoses printer issues based on LED status (OFF, Solid Green, Green blinking, Red blinking) and provides recovery.
Addresses common printing problems like 'Not Printing', 'Paper Jam', and 'Poor Print Quality' with solutions.
General| Resolution | 203 dpi |
|---|---|
| Print Speed | 4 ips |
| Print Method | Thermal Transfer / Direct Thermal |
| Print Length | 90 inches |
| Memory | 8 MB SDRAM, 4 MB Flash |
| Interface | USB |
| Maximum Print Length | 90 inches |
| Communication Interface | USB 2.0, RS-232 |
| Label Width | 1.18" - 4.33" (30 - 110 mm) |
| Label Thickness | 0.003 - 0.008" (0.08 - 0.2 mm) |
| Power Supply | AC 100-240V, 50/60Hz |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -40°C to 60°C |
| Humidity | 25-85% non-condensing |
| Dimensions | 232 mm x 156 mm x 288 mm |
To Next Page