TSC Prontronix TTP-244CE User Manual

23
6. TroubleShooting
This section lists the common problems that according to the LED status and other problems you may encounter when operating
the printer. Also, it provides solutions.
LED Status
LED Status / Color
Printer Status
Possible Cause
Recovery Procedure
OFF
No response
No power
* Turn on the power switch.
* Check if the green LED is lit on power supply. If it is not lit on,
power supply is broken.
* Check both power connections from the power cord to the power
supply and from the power supply to the printer power jack if
they are connected securely.
Solid Green
ON
The printer is ready to use
* No action necessary.
Green with blinking
Pause
The printer is paused
* Press the FEED button to resume for printing.
Red with blinking
Error
The out of label or the
printer setting is not
correct
1. Out of label
* Load a roll of label and follow the instructions in loading the
media then press the FEED button to resume for printing.
2. Printer setting is not correct
* Initialize the printer

TSC Prontronix TTP-244CE Specifications

General

Resolution	203 dpi
Print Speed	4 ips
Print Method	Thermal Transfer / Direct Thermal
Print Length	90 inches
Memory	8 MB SDRAM, 4 MB Flash
Interface	USB
Maximum Print Length	90 inches
Communication Interface	USB 2.0, RS-232
Label Width	1.18" - 4.33" (30 - 110 mm)
Label Thickness	0.003 - 0.008" (0.08 - 0.2 mm)
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	5°C to 40°C
Storage Temperature	-40°C to 60°C
Humidity	25-85% non-condensing
Dimensions	232 mm x 156 mm x 288 mm