3.8 Loading Label in Cutter Mode (Option)
1. Open the printer top cover. Refer to section 3.4. to load the media then feed the paper.
2. Lead the media through the cutter paper opening.
3. Move the media guides to fit the label width by turning the guide adjuster knob.
4. Disengage the top cover support and close the top cover gently.
5. Use software to set the media sensor type and calibrate the selected sensor.( Please refer to chapter 4 and 5)
Note:
Please calibrate the gap/black mark sensor when changing media.
Regular cutter specification:
Full cut: Media thickness: 0.06~ 0.19mm
Media type: receipt and label liner w/o glue
Partial cut: Media thickness: 0.06~0.12mm
Media type: receipt and label liner w/o glue
Label length: 25.4 mm ~ max. print length
*Except for the linerless cutter, all regular/heavy duty/care label cutters DO NOT cut on media with glue.
To Next Page
Loading...
