TSI Instruments AEROTRAK 9310 - Page 52

3-22 AeroTrak
®
Portable Airborne Particle Counter
Print Setup Screen
A hard copy of a sample set or statistics can be printed from the
instrument using an optional thermal printer. Use this screen to set print
parameters. Press OK when finished. These selections will apply when
printing automatically or when printing from the Data tab page.
Field
Description
Serial Number
Indicates that the serial number of the particle counter used
to collect the data will be printed.
Model Name
Indicates that the model number of the particle counter used
to collect the data will be printed.
Separator
Indicates a line separator will be printed after the Model
Name and Serial Number in the header of all printouts.
Differential
Indicates that the differential value of the data will be printed.
Cumulative
Indicates that the cumulative value of the data will be
printed.
Last Calibration
The date and time the instrument was last calibrated by TSI.
Statistics
A statistical summary is printed after the sample data.
Statistics Only
A statistical summary is printed instead of sample data.
NOTE
Printer paper has a colored strip printed on the last few feet of each roll
to indicate when it is time to change the paper roll.