20 Electronic Balancing Tool EBT720/EBT721 and ProHood PH720/PH721
Delete Sample Data
You can delete data in three ways: 1) delete all Sample data in all Test IDs, 2) delete all Sample data for a
single Test ID, and 3) delete only the last Sample currently stored in a Test ID.
Delete all Sample Data
1. Press to display CHANGE Test ID.
2. Press until DELETE appears.
3. Press
. The display shows DELETE ALL.
4. Press
. The instrument counts down from 3 to 0 and then deletes all Sample data.
Note: This countdown gives you time to change your mind. If you decide not to delete all samples
after pressing
, press ESC before the count reaches 0. Samples will not be deleted.
Delete the Samples Stored in a Single Test ID
1. Press to display CHANGE Test ID.
2. Press until DELETE appears.
3. Press
. The display shows DELETE ALL.
4. Press . The display shows DELETE Test ID.
5. Press
. The display shows the currently selected Test ID.
6. Use and to display the Test ID whose Samples you want to delete.
7. Press
. “DELETE” flashes while all Samples for the selected Test ID are deleted.
8. Repeat steps 6 and 7 to delete other Test IDs.
Delete a Single Sample
1. Press to display CHANGE Test ID.
2. Press until DELETE appears.
3. Press
. The display shows DELETE ALL.
4. Press . The display shows DELETE Test ID.
5. Press . The display shows DELETE #.
6. Press
. The display shows the currently selected Test ID.
7. Use and to display the Test ID containing the Sample you want to delete.
8. Press
. The display shows the last Sample in the Test ID.
9. Press
. “DELETE” flashes while the last Sample of the selected Test ID is deleted.
10. Repeat step 9 to delete other Samples in the selected Test ID.
To Next Page
Loading...
Need help?
General
