Technical Section
Press the SELECT key to save the new
positive low alarm set point.
Three short beeps will sound
indicating that the data is being
saved.
Immediately after the data is saved,
the PresSura controller will return to
the menu level displaying the menu
title on the top line of the display and
the menu item on the bottom line
(goes to step 3).
WARNING: If the MENU key was pressed instead of the SELECT key, the
new data would not have been saved, and the PresSura
controller would have escaped back to the menu level shown in
step 3.
Press the MENU key once to return to
the menu level:
Press the MENU key a second time to
return to the normal operating level:
Unit is now back in normal
operation
To Next Page
Loading...
