Need help?Do you have a question about the TSI Instruments EVERWATCH 8610 and is the answer not in the manual?
General| Sensor Type | Electrochemical |
|---|---|
| Gas | Oxygen (O2) |
| Resolution (O2) | 0.1% |
| Operating Temperature | -20 to 50°C |
| Alarm | Visual and audible alarms |
| Response Time | < 15 seconds |
| Operating Humidity Range | 15 to 90% RH (non-condensing) |
| Power Supply | 3.6V Lithium battery |
| Battery Life | > 24 months typical |
Explains the purpose and function of the EverWatch monitor.
Describes the monitor's lights and display indicators.
Details the front panel display, keys, and lights of the monitor.
Explains visual and audible alarm conditions and operation.
Lists information needed before contacting TSI for support.
Describes the general programming sequence for the monitor.
Provides a step-by-step guide to using the keypad for programming.
Demonstrates how to program a specific setting using keystrokes.
Introduces and lists items in configuration and calibration menus.
Details the software items available for calibration.
Details the software items available for configuration.
Outlines the steps required to calibrate the EverWatch monitor.
Provides instructions for cleaning the velocity sensor.
Lists available field-replaceable components and contact info.
Addresses blank display and no power symptoms.
Discusses display fluctuations and turbulence effects.
Covers differences between indicated and average velocities.
Troubleshooting incorrect analog output.
Troubleshoots issues with RS-485 network communication.
Lists specifications for the face velocity display.
Lists specifications for the analog output signal.
Details on using Modbus protocol for communication.
Describes the connections on the J1 terminal strip.
Visual representation of the monitor's wiring connections.
A template for documenting the unit's initial setup.
Explains key sequences to access calibration/configuration menus.
To Next Page
