Technical Section
Figure 2: Programming Flow Chart
Programming Example
The following example demonstrates the programming keystroke sequence. In this
example the face velocity low alarm will be programmed for 60 ft/min.
1. Press the NORMAL key to access the main menu. CAL will be indicated on
the display.
2. Press the ▼ arrow key once. CONF should be indicated on the display.
3. Press the NORMAL key. The first menu item (LAL) is now displayed.
Note: If “COdE” is flashing an access code must be keyed into the unit
before access will be allowed. The access codes are printed on the
last page of the manual.
To Next Page
Loading...
