26 Appendix E
APPENDIX E
Access Codes
These are the access codes to the calibration and configuration menus. When an access
code is required, pressing the following key sequence will provide access to the required
menu.
Key # Calibration Configuration
1 RESET LOW ALARM
2 LOW ALARM TEST
3 NORMAL RESET
4 TEST HIGH ALARM
5 RESET LOW ALARM
If the access code is entered correctly, the first menu item is displayed.
The audible alarm sounds briefly each time a keystroke has been entered. The access
code must be entered within 40 seconds (approximately eight seconds per keystroke). If
more than eight seconds elapses between keystrokes, the monitor returns to the normal
operational mode.
The audible alarm sounds, an error message (Err) flashes on the display, and the
configuration menu is exited if an incorrect access code in entered.
To Next Page
Loading...
