AMU2-2MA MKIII 4 ISSUE 1
SAFETY
Installation.
Unless otherwise stated TSL equipment may be installed at any angle or position
within an operating temperature range of 5? - 30? C .
All TSL equipment conforms to the EC Low Voltage Directive:
EC Low Voltage Directive (73/23/EEC)(OJ L76 26.3.73)(LVD).
Amendment: (93/68/EEC) (OJ L220 30.8.93).
In all cases the frame of the equipment must be earthed on installation.
The earth pin on the IEC mains inlet connector is connected to the metal frame of the
equipment, to 0 volts on the internal DC PSU and to signal ground, unless otherwise
stated. All metal panels are bonded together.
Check that the voltage selector setting (if fitted) and the fuse rating is correct for the
local mains supply.
WARRANTY, MAINTENANCE AND REPAIR
All TSL equipment is guaranteed for one year from the date of delivery to the
customer’s premises. If the equipment is to be stored for a significant period, please
contact TSL concerning a possible extended warranty period.
Failure during warranty
If any TSL product should fail or become faulty within the warranty period, first please
check the PSU fuses.
All maintenance work must be carried out by trained and competent personnel.
If equipment has to be returned to TSL for repair or re-alignment, please observe the
following overleaf:
To Next Page
Loading...