TTI FABRICATION CPST-65 - Connection to Electrical Power; Electrical Connection Safety and Requirements

8
6. CONNECTION TO ELECTRICAL POWER
WARNING
To ensure your safety and the proper functioning of the device, the electrical
connections must be performed by a qualified electrician according to national
codes, provincial and local regulations.
A circuit breaker must be installed close to the heat pump, in an accessible location.
Never open the electrical box without shutting off the power to all sources used for the operation of the
heat pump. If your heat pump has a pool pump control option, remember to close the circuit breaker to
this pump.
The spec sheet for the heat pump contains all the requirements for voltage and amps.
If the power cord is damaged, it must be replaced by a qualified electrician.