Either rechargeable or disposable cells may be used; fit into the battery tray observing the polarity
marked in the tray. Suitable cells are as follows:
Rechargeable: 2 Amp hour, e.g. NCC200, AN220, VR2C, RSH1.8, P-180C.
Disposable: Alkaline, e.g. MN1400.
Zinc Carbon, e.g. R14B, R14S.
If batteries are fitted it is essential that the disposable/rechargeable selector switch on the rear
panel is positioned correctly before applying external power via the AC socket.
WARNING! If disposable batteries are fitted and the selector is set in the rechargeable
position, there is a risk of explosion if the meter is connected to an AC supply.
The Rechargeable batteries are charged at a ‘trickle’ rate of C/20; the time to fully charge from
completely discharged is approximately 28 hours.
Low battery condition is indicated by showing the battery symbol in the top left-hand corner of the
display; when this symbol shows, approximately 5% of battery life remains.
Handle
Adjust the handle position by pulling out the ends and rotating the handle to the desired position.
There are sixteen possible positions including five facing forward which provide upward tilts for
the most convenient bench operation. The handle may be swung out of the way to the back or
front of the instrument if no tilt is required. The natural spring in the handle will lock it into position
when the handle is released.
11
Telemeter Electronic GmbH | Joseph-Gaensler-Str. 10 | Phone +49 906 70693-0 | Fax +49 906 70693-50 | www.telemeter.info 12
To Next Page
Loading...