three spaces. The following two fields each of 8 digits, contain the measurement value and
measurement units respectively, in exactly the same format as the response to the standard
READ? command, see that command section for details.
TRIG
With the data logger on, a reading will be stored each time the TRIG command is set. Since the
remote command is OR’ed with the internal timer, either both can be run together or the internal
timer can be disabled by setting the interval to 0000 seconds.
CANCEL
Stops the logger running.
LOGCLEAR
Cancels the logger function, if it is running, and clears the results from the logger memory.
Calibration Commands
SETCAL
Used for calibration only - refer to Service Manual.
STEPCAL
Used for calibration only - refer to Service Manual.
REJ50
Optimizes analogue-to-digital converter for 50Hz rejection; see Calibration section of manual for
further explanation.
REJ60
Optimizes analogue-to-digital converter for 60Hz rejection; see Calibration section of manual for
further explanation.
40
Telemeter Electronic GmbH | Joseph-Gaensler-Str. 10 | Phone +49 906 70693-0 | Fax +49 906 70693-50 | www.telemeter.info 41
To Next Page
Loading...