Default Settings
The meter is put into the following default condition as a result of a system reset (hold Cancel
down at switch on) or by the ∗RST remote command.
Function set to DC Volts, single measurement mode.
Autoranging mode set.
All first level modifiers cancelled, including Ohms Null.
All second level modifiers cancelled.
Ax + b factors set to A = 1.0000 and b = 00000
Limits set to 0.0000
Delta % reference set to 10000
dB reference impedance set to 600Ω
Watts reference impedance set to 50Ω
Set data logger off and timer to 0000 seconds but preserve logger store contents.
Bus address set to 1 (not by ∗RST)
Baud rate set to 9600 (not by ∗RST)
Calibration constants and the 50/60Hz rejection setting are unaffected by a system reset.
41
Telemeter Electronic GmbH | Joseph-Gaensler-Str. 10 | Phone +49 906 70693-0 | Fax +49 906 70693-50 | www.telemeter.info 42
To Next Page
Loading...