Printing
The current display reading or the logger results can be output via the RS232 port. Connect the
device to the RS232 port. Press Shift then Baud (the shifted function of Run) and use the Range
Up/Range Down keys to select an appropriate Baud rate; exit Baud rate selection by pressing
Baud again or Esc. The other parameters are fixed and are as follows:
Start bits 1
Data bits 8
Parity None
Stop bits 1
With the interface set up a reading will be sent to the device each time the Print key is pressed.
Printing Data Logger Readings
Set the interface up as described in the appropriate section above. Press Shift, Logger Rcl (the
shifted function of EDIT) to recall the logger results to the display. Pressing Print whilst in this
logger display mode will cause the complete contents of the logger to be printed. Each result is
printed on a separate line and consists of the store location, value and measurement units.
26
Telemeter Electronic GmbH | Joseph-Gaensler-Str. 10 | Phone +49 906 70693-0 | Fax +49 906 70693-50 | www.telemeter.info 27
To Next Page
Loading...