Template
5
PREPARING TO INSTALL
5.1 Line Drawing
5.2 Determining Lever Handing
Draw a horizontal center line inside and outside the door at 1 meter from the ground.
Fold the template, make the handle center line align at the door horizontal center line,
then draw out the hole lines at front and side.
The handle of the door is determined from the secure side, The term"Secure"means
the side from which you initially unlock and enter the door from outside, or the hinge
side for left/right open.
Standing outside the door, there is left/right open and push/pull to open
as the below diagram:
4
K71 0-85# 240X2 2
Ins talla tion Temp late
Pla ntill a de Inst alaci ón
Шаб лон уст ановк и
설치 템플 릿
เทม เพลต การต ิดตั ้ง
تﯾﺑ ﺛﺗﻟا ب ﻟﺎﻗ
DOO R SIDE
ARR OW UP
Stri ke slot: 198.5 X24.5 ;Dept h:2
Stri ke box:1 42X21 ;Dept h:24
Facep late sl ot:24 1x23; Depth :3
Mor tise slo t:180 x18;
DOO R FRONT/ BACK
708 5 Depth :90
608 5 Depth :80
508 5 Depth :70
458 5 Depth :65
408 5 Depth :60
358 5 Depth :55
1 met er to grou nd
Left Push Right Push Left Pull Right Pull
3
5.3 Change Handle Direction
1.1Use the Allen key to loosen the screw in the picture.
1.2 Turn the handle 180 degrees counterclockwise.
1.3 Tighten the screw and adjust the handle.
1.Adjust the Front Handle Direction(From right to left)
2. Adjust the Back Handle Direction
2.1 Use the Allen key to remove the screw in the photo.
2.2 Turn the handle 180 degrees clockwise.
2.3 Tighten the screw and adjust the handle.
Make sure the arrow points to the right
one position points according to the
direction of the door on the clutch, if not,
you cannot unlock the door
Trepanning Screwdriver
To Next Page
Loading...