TTS Pro-Bot - Menu System

Menu System
Using the menu key gives you access to a number of other functions within Pro-Bot.
Special commands can be added to your program, different configuration options can
be selected and procedures can be managed.
The Menu system is entered by pressing the key above the display. You are
then given a list of menu selections. The first in the list is always <Back>, which allows
you to go back one level of the menu. Use the up and down scroll keys to move the
highlight to the menu item you want to select, then press again to select that
item.
The Menu system is structured as follows:
Back
New Proc
o
Edt Proc
o
Config
o
•
•
o
•
•
Sensors (NB. in version 1 all sensors are enabled together)
o
o
o
<Select>
<Select>
Units
Cm
Pro-Bot
End of Cmd
Beep on/off
Pause on/off
Touch on/off
Sound on/off
Light on/off
Goes back one level
Edit procedure with empty program
Edit procedure with existing program
Units are in Cm
Units are in Pro-Bot lengths
Enable beep after commands
Enable pause after commands
Enable both touch sensors
Enable sound sensor
Enable light sensor
14