TuffStuff CFM-500 - Safety Precautions; General Safety Guidelines; Push Pull Pin Engagement Warning

S
afety First
R
egardless of how enthusiastic you may be about getting on
y
our equipment and exercising, take the time to ensure that your
s
afety is not jeopardized. A moment’s lack of attention can result
n an accident, as can failure to observe certain simple safety
p
recautions.
1
. Read, study and understand the Owner’s Manual and all the
warning labels on this product. Furthermore, it is
recommended to familiarize yourself and others with the
proper operation and workout recommendations for this Tuff
Stuff product prior to use. Some of this information can be
obtained in this Owner’s Manual, as-well-as from your local
Tuff Stuff retailer.
2
. It is imperative that you retain this Owner’s Manual and be
sure all warning labels are legible and intact. Replacement
Owner’s Manuals and labels are available from your local Tuff
Stuff retailer.
3
. Consult with your physician before beginning any exercise
program.
4
. Use proper discretion when children are present.
5
. Frayed or worn cables can be dangerous and may cause
injury. Periodically check these cables for any indication of
wear.
6
.Keep hands, limbs, loose clothing and long hair well out of the
way of moving parts.
7
. Do not attempt to lift more weight than you can control safely.
8
. Inspect the Compact Frontal Machine for any sign of wear on
parts, hardware becoming loose or cracks on welds. If a
problem is found do not use or allow the machine to be
used until the defective part is repaired or replaced.
9
. Pay special attention to the Push Pull Pins (#82 and #62)
located on Press Bar Selector Housing (#2), Front Upright
(#4) and Leg Extension Bench Frame (#18). See Fig.1. Be
sure they are fully engaged into the selectorized holes. Refer
to Fig. 2 for further illustration of this warning.
Safety Precautions
Fig. 1 Illustration above depicts the location of Push Pull Pins 1/2
”
Special (#82) and Push Pull Pin 1/2” (#62) on this unit.
Push Pull Pin
1/2” Special (#82)
Push Pull Pin
1/2” (#62)
Fig. 2
Warning: Check that all Push Pull Pins 1/2” (#82
,
#62) are fully engaged into the selectorized holes.
Push Pull Pin
Fully Engaged
C
FM-500 Compact Frontal Machine
2
Push Pull Pin
1/2” Special (#82)