TuffStuff SPT-6X - Registration, Service & Assembly; Product Registration Process; Obtaining Service and Parts Information; Assembly Tips and Requirements

Thank you for purchasing the SPT-6X Six-Pak Trainer.
This machine is part of the TuStu Fitness line of quality strength training equipment.
To maximize your use of the equipment, please study the Owner’s Manual thoroughly.
• Allowamplespacearoundthemachineforsafeunrestricteduseand
easier access.
• Insertallboltsinthesamedirection.Foraestheticappearance,insert
all bolts in the same direction unless specied (in text or illustration) to
do otherwise.
• Leaveroomforadjustments.Donotfullytightenfastenersuntil
instructed in the assembly steps to do so (to prevent any diculty with
alignment of parts during the assembly process). When not instructed,
tighten fasteners such as bolts, nuts and screws so the unit is stable,
but leave room for adjustments.
Assembly Tips
Read all “Notes” on each page before beginning each step.
While you may be able to assemble the SPT-6X using the illustrations only,
IMPORTANT safety notes and other tips are included in the text.
Some pieces may have extra holes that you will not use. Use only those
holes indicated in the instructions and illustration.
NOTE: With so many assembled parts, proper alignment and adjustment
is critical. While tightening the nuts and bolts, be sure to leave room for
nal adjustments.
CAUTION: Obtain assistance from TuStu Fitness if you have diculty
assemblying the SPT-6X. Please do not attempt to complete the assembly
as this could result in equipment failure and serious injuries to the users.
Symbols & Description
Loosely Tighten
70%
100%
Fully Tighten
Required Tools
The basic tools that you will need to assemble the SPT-6X but are not
limited to:
• 1/2”,9/16”,3/4”,7/8”CombinationWrenches
• RatchetWrenchwith1/2”,9/16”,3/4”sockets
• CrescentAdjustableWrench
• Externalretainingringpliers
• SuperLube®spraylubricantandgrease
• Rubbermallet,measuringtape&utilityknife
• Windexorhouseholdglasscleaner
Assembly Requirements
• Aminimumoftwostrongpersonsarerequiredforthisassembly.
• FollowtheseinstallationrequirementswhenassemblyingtheSPT-6X.
• Layoutyouroorplanbeforeassemblying.
• SetuptheSPT-6Xonaclean,solid,atsurface.Asmooth,atsurface
under the machine helps keep it level.
Registration
To avoid unnecessary delays on warranty parts and to insure that a
permanent record of your purchase is on le with our company, be
sure to register online at:
http://www.tustutness.com/productregistration.jsp
within 10 days of purchase.
Obtaining Service
Please use this Owner’s Manual as your guide to all parts included in
your shipment. When ordering parts, you must specify the part number
and description from this manual. Use only genuine TuStu Fitness
replacement parts when servicing the equipment. Failure to do
so will void warranty and could result in serious injury or death.
For information about product operation or service:
Phone: 909-629-1600 Toll Free 888-884-8275
Fax: 909-629-4967
E-mail: service@tustu.net or service1@tustu.net
Hours: M–F 8:00 – 4:30 PST
Or write to: TuStu Fitness Equipment Inc.
Customer Service
13971 Norton Avenue, Chino, CA 91710
Retain this Owner’s Manual for future reference when ordering
service or parts. To assist you better, please be prepared to
provide the following information:
1. Model Number 2. Place of Purchase
3. Serial Number 4. Part # and Description
Loosely Tighten
Loosely tighten all hardware in this step. DO NOT Fully
Tighten. Some component(s) may need pre-assembly
and or alignment during the assembly process.
Fully Tighten
Wrench tighten all hardware in this step.
Registration, Service & Assembly
4 SPT-6X Six-Pak Trainer
www.tuffstuffitness.com