Tulp B-Fire 50 - 2 User Instructions; First Time of Operation; Remote Control Overview

Manual Tulp gas fires EN
P. 4
2. User instructions.
2.1 First Time of Operation
Before igniting the appliance, ensure that all packaging, safety stickers and any protective wrapping
have been removed, and that the glass has been cleaned, including all fingerprints from the glass.
Ensure that the room is adequately ventilated the first time that the appliance is ignited, we would
recommend opening windows if possible. Run the appliance at full setting for a few hours so that the
paint gets an opportunity to fully cure. During this period it is possible for some fumes and vapours to
be given off. We would recommend keeping children and pets out of the area at this time.
2.2 Remote control overview
This Tulp Gas appliance has been constructed with an advanced remote control system. This consists of
three main parts: Handset, receiver (fig. 1.1) and gas valve with manual override (fig. 1.2). The gas
control valve and the receiver box are behind the access door. This is also where the product data label
is located.
Fig. 1.1 Receiver
Fig. 1.2 Gas control
 With each successful button
press of the handset, the
receiver will emit an audible
signal.
 Always leave the dial on the gas
control valve set to “ON”, the
“MAN” position is only for servicing
and emergency use if the handset is
misplaced, or the battery fails.
 A toggle switch “0/1” is present on
the gas control valve, this should be
put into the “0” position in the
appliance is not operated for a long
time. Pay attention: when this is on
“0” you cannot operate the fire!!
 The heat output can be manually
adjusted by turning the setting knob
on the gas control valve.