What to do if Tuncmatik UPS is overloaded?
If your Tuncmatik UPS is overloaded, remove excess loads from the UPS output. This may occur when devices connected to the UPS are fed directly by the electrical network via the Bypass or after repetitive overloads, the UPS is locked in the Bypass mode. In the latter case, remove excess loads first, then shut down the UPS and restart it.
What to do if my Tuncmatik UPS battery backup time is shorter than expected?
If the battery backup time of your Tuncmatik UPS is shorter than expected, it may be because the batteries are not fully charged. Charge the batteries for at least 7 hours and then check capacity. Another possible cause is a battery defect.
What to do if fault code 43 is shown on Tuncmatik UPS?
If fault code 43 is displayed on your Tuncmatik UPS, it means the UPS is overloaded for too long and has become faulty, causing it to shut down automatically. Remove excess loads from the UPS output and restart it.
What to do if fault code 14 is shown on Tuncmatik UPS?
If fault code 14 appears on your Tuncmatik UPS, it indicates a short circuit on the UPS output, causing it to shut down automatically. Check the output wiring and the connected devices for any short circuit.
Why is the icon flashing and alarm beeping on my Tuncmatik UPS?
The icon flashing and alarm beeping every second on your Tuncmatik UPS could indicate several issues: * The external or internal battery is incorrectly connected: Check if all batteries are connected well. * Fan is locked or not working; or the UPS temperature is too high: Check fans and notify dealer.
How to disable EPO function on Tuncmatik UPS?
If the icon and warning code are flashing on the LCD display and the alarm is beeping every second on your Tuncmatik UPS, the EPO (Emergency Power Off) function may be enabled. To disable it, set the circuit in the closed position.
What to do if Tuncmatik UPS has no display even though the mains is normal?
If there is no display or alarm on your Tuncmatik UPS front panel even when the mains power is normal, check if the AC input power cable is firmly connected to the mains.
Covers moving, storing, and preparing the UPS environment.
Safe installation practices and operational guidelines.
Compliance with Electromagnetic Compatibility standards.
Steps for unpacking, inspecting, and identifying UPS rear panel components.
Detailed procedures for single UPS and parallel system installations.
Installing monitoring software and configuring UPS settings via LCD.
Explains buttons, LEDs, LCD panel, and audible alarms.
Describes various UPS operating modes and how status is displayed.
Interpreting fault codes, warning indicators, and error messages.
Guide to diagnosing issues and performing essential maintenance tasks.
Lists detailed technical parameters, performance, and physical data.
General| Input Voltage | 220/230/240 VAC |
|---|---|
| Output Voltage | 220/230/240 VAC |
| Typical Recharge Time | 4-6 hours recover to 90% capacity |
| Protection | Overload, Discharge, and Overcharge Protection |
| Outlets | 3 x IEC C13 |
| Backup Time | Up to 30 minutes (depending on load) |
| Communication Interface | USB |
| Weight | 9.8 kg |
To Next Page
