Programming the Vi+ using a Series Telephone
Page 7 Ver 1 4/24/2015
Unit ID numbers
The Vi+ sends a unit ID number to the monitoring center when an alarm is sent. The
number identifies which Vi+ is sending the alarm. Unit ID number 1 must be programmed
into the Vi+ (default 995) in order for an alarm to be sent. The unit ID number may be the
same for all monitoring centers and personal recipients. If required the Vi+ can be
configured to send a different unit ID to each telephone number it is programmed to call.
Adding/Changing a unit ID
Unit IDs can be programmed into the Vi+ by pressing:
Unit ID (max 12 digits)
Sets Unit ID 1
To set Unit ID 2 replace 02 with 12
To set Unit ID 3 replace 02 with 13
To set Unit ID 4 replace 02 with 14
Deleting a unit ID
To delete a unit ID press:
Deletes Unit ID 1. Replace 02 with the numbers identified above to delete the appropriate Unit ID
number.
Prefix numbers
A function can be enabled/disabled to ensure a prefix number is inserted before all dialed
numbers from the Vi+ e.g. dialing 9 when using a PBX. This can be achieved by pressing:
Prefix (max 8 digits)
NOTE: If no unit ID is linked to a telephone number, the first valid code will be used. The actual number
of digits sent to the alarm receiver depends upon the type of monitoring center being used. Please
contact your monitoring center for more information.
To Next Page
Loading...
