turbofan EC40D10 User Manual

30
21 • SPECIAL PROGRAMMES
Press button 13, display 7 will read [CL],
press knob 1 to confirm.
Display 8 now reads [run], press button
9 to
activate the MANUAL cleaning programme,
simplified below.
The display reads [rAF] if the chamber
temperature is too high, [Att] if the chamber
temperature is too low. When the temperature
is reached, the writing [dEt In] will appear,
an acoustic signal will notify that it is time to
open the door and spray the detergent into the
cooking chamber.
Close the door and press button 9 to
reactivate the cleaning cycle. From this
moment on, no action is required by the
operator until the programme has been
completed.
If consistent dirt residue is deposited on the
drainage filter located at the centre of the
cooking chamber base, clean in order to
guarantee the free flow of water and detergent.
The end of the programme is signalled by
a cyclical acoustic sound, open the door
to deactivate the sound.
Display 7 will read [End], press button 13
to exit the cleaning menu.
Turn the oven off using knob 1.
IMPORTANT
Thoroughly rinse the inside of the cooking
chamber to remove any detergent
residue. Use the sprayer (optional) or a
similar one that is available.
Wipe the front cooking chamber gasket
with a sponge in order to keep it from
deteriorating prematurely.
21.1 • ACTIVATING MANUAL CLEANING
CYCLE [CL]
MANUAL CLEANING
240066-1

turbofan EC40D10 Specifications

General

Brand	turbofan
Model	EC40D10
Category	Oven
Language	English