14 Milan Series
Using Milan Loudspeakers with Subwoofers
Improved bass response and higher overall sound pressure level can be achieved by adding sub-bass
loudspeakers to the Milan system. This also reduces mechanical stress on the Milan loudspeaker’s low
frequency driver, since most of the low frequency content in the signal is routed to the subwoofer.
It is recommended that you connect the full range signal from the mixer fi rst to the
subwoofer(s), and then link from the subwoofer(s) to the Milan loudspeaker.
When using Milan with subwoofers, best results will be obtained by fi ltering the
frequency reponse of the individual cabinets in order to avoid an overlap in the
combined response. Move the LOW CUT switch to the 100 HZ position (up).
Using Milan as a Floor Monitor
When using the Milan loudspeaker as a fl oor monitor it is
recommended that you activate the LOW CUT switch to avoid any
low frequency boominess that can occur due to the proximity
of the fl oor, which can detract from clear and intelligible
monitor sound, particularly vocals.
In order to further improve vocal intelligibility in fl oor monitors you can also reduce the level of the
BASS CONTROL as required.
If you are using Milan as part of a larger multi-channel monitor system and where drums may be part of
the monitor mix it is recommended that kick drum EQ is used sparingly and carefully, aiming to cut rather
boost at bass frequencies.
To Next Page
Loading...
Need help?
General
