Quickstart Guide 5
Stereo PA with an external mixer
Two Milan loudspeakers form the left and right elements of a stereo PA setup with all signal sources
connected to an external mixing console. Ensure that the MIC/LINE switch is set to LINE on both
loudspeakers. Set the LOW CUT switch to the ‘OFF’ position when not using subwoofers. For mixed vocal
and music program material set the PROG switch to 'MUSIC'. Bring up the master faders on the mixer,
ensuring that the outputs are not clipping, and then adjust both loudspeakers’ level controls to the desired
loudness. Adjust the bass and treble controls as required to acheive a suitable frequency response from
the system. For consistent balance and response set the level controls and tone controls to approximately
the same positions on both cabinets.
To Next Page
Loading...
Need help?
General
