To Next PageTo Next Page
Need help?Do you have a question about the Turnigy Quad 4x6S and is the answer not in the manual?
Four independent 100W outputs, 400W total, 10A max current, efficient cooling.
Built-in individual cell voltage balancer for charging and discharging Li-ion batteries.
Auto-charge current, capacity, temperature, time limits, and input power monitoring.
Emphasizes supervision, environment, power source, surface, and understanding battery info.
Lists battery types that should not be charged or discharged by this unit.
Reminds users to check battery type, current, connections, and mixed circuits.
Explains charge quantity calculation, charge current, lead selection, and connection advice.
Warns about mixing parallel/series connections in Li-ion packs and recommends series only.
Defines discharge purpose, avoiding deep discharge, and setting final voltage.
Reiterates importance of safety notes to prevent violent damage and fire.
Suitable for 3.3V, 3.6V, 3.7V, 3.8V Li-ion cells using CV/CC method, requires correct current/voltage.
Specific warning about LiHV mode supporting only 4.35V and prohibition for other Li-ion types.
For balancing Li-ion cells during charging, requires a balance lead.
Monitors and normalizes cell voltages during storage/discharge, stops on abnormality.
Identifies low cell voltage errors and potential bad cells or connection breaks.
Indicates incorrect polarity connection and emits an audible sound.
Indicates an interrupted battery connection and emits an audible sound.
Indicates a short-circuit of the output termination and emits an audible sound.
Indicates an incorrect input voltage and emits an audible sound.
Indicates that the battery pack voltage has been selected incorrectly.
Indicates a charger malfunction, advising professional advice.
Errors for battery voltage lower/higher than set, or cell voltage issues.
Indicates wrong connector or cable connection detected.
Indicates internal temperature is too high, advising to cool down.
Indicates processor cannot control feeding current, requiring repair.
Covers product for one year from purchase date against material or operational defects.
General| Input Voltage | 11-18V DC |
|---|---|
| NiCd/NiMH cells | 1-15 cells |
| Pb battery voltage | 2-20V |
| Smart battery | No |
| Battery Types | LiPo, LiFe, LiIon, NiMH, NiCd, Pb |
| Balance Ports | JST-XH |
| Channels | 4 |
| LiPo/LiFe/Lilon cells | 1-6S |
| Current drain for balancing | 300mA |
| Cooling | Fan |
| Discharge circuit power | 20W (4x5W) |
| Charge current range | 0.1-5.0A |
| Discharge current range | 0.1-1.0A |
