If you cannot hear the game audio when first powering on the headset and transmitter, check to see if they are “paired”, which means
they’re synchronized to ensure they work together. When the headset and transmitter are communicating properly, the Power LED on
the front panel of the transmitter will be on solid. If this LED is slowly pulsing instead, it means the transmitter can’t communicate with the
headset. If this is the case and your headset is not paired with the transmitter, then follow the instructions below for pairing:
2 feet
Maintain a distance of at least
2 feet between the headset and
transmitter when pairing.
IMPORTANT!
1. Make sure the headset and transmitter are turned off and
they are at least 2 feet away from each other.
2. Power on the transmitter by connecting it to a free USB
port on your gaming console. Then press and hold the PAIR
button on the transmitter. The transmitter LED will begin to
flash rapidly, then release the PAIR button.
3. Press and hold the headset POWER button for about 6
seconds until the LED begins to flash rapidly, then release
the POWER button.
4. Wait for the headset and transmitter to pair. This process
could take up to 30 seconds.
If pairing is successful, the LED on the transmitter should be
on solid and the headset LED should be flashing about once
per second, indicating that the units are paired.
If pairing fails, repeat steps 1 through 4. It may take up to 5
attempts to pair successfully.
If you have followed these instructions and still have issues with
the pairing process, please contact Technical Support:
www.turtlebeach.com/support
click “Contact Support”
NO GAME AUDIO?
Need help?
General
