Rebar Scanner A60+
18
press the ENTER key to enter into corresponding function interface.
Figure 3-12 interface of transferring data
3.2.6.1 USB transfer
USB transfer interface is shown as figure 3-13. Press the ENTER
key to carry out transfer and press the ESC key to return function
selection interface without transferring data. During transfer, prompt
Transferring…，as figure 3-14 shows. After transfer is finished,
prompt Transfer end，as figure 3-16 shows. Then press any key to
return function selection interface.
Connect by USB
[ESC] : cancel [ENTER] : confirm
Figure 3-13 USB transfers
Transferring…
[ESC] : cancel
Figure 3-14 USB transferring
3.2.6.2 COM port transfer
USB output
COM output
To Next Page
Loading...