2023/11/06 14:11 27/41 OPUS User's Manual
User's manuals - https://wiki.two-notes.com/
Using OPUS as an Acoustic DI
OPUS can be used in tandem with your electro-acoustic guitar for an enhanced DI live feed, and
expanded possibilities when using OPUS in a recording scenario.
1. Connections & Routing
Connect your acoustic guitar’s output to OPUS’s input, and set the IN LEVEL to INST/+12dB. For
optimal use, we suggest bypassing both the TSM™ Pre- and Power-amp processing within your preset.
2. Loading Acoustic IRs
To load a static Impulse response (be it an Acoustic Impulse response or one captured from a
traditional guitar cabinet) simply navigate to the IR loader tab in Torpedo Remote and select up to
two files to load onto either of the IR Slots (IR A and IR B). You can then use the IR A and IR B channel
controls to refine the blend of your IRs within the context of your OPUS preset.
In some instances you may want to blend an IR affected signal with the natural sound of your DI’d
acoustic guitar. In order to action this, simply Bypass (the “B” switch situated within the IR A or IR B
mixer pane) to route your dry signal through the IR Loader processing block. By using the channel
faders on either IR A or IR B, a mix of your dry and wet signal can be achieved. Please note, this
bypass processing simply removes any IR processing on your source signal; any processing outside of
the IR processing blocks will still be applied to your dry signal including TSM™ Pre- and Power-amp
emulation and OPUS’ suite of Post FX.
Top Tip: In order to fuse a full OPUS-processed signal chain with an unaffected dry signal, we
To Next Page
Loading...
Need help?
General
