Need help?Do you have a question about the Two-Rock Studio Signature and is the answer not in the manual?
Read, keep, and heed all instructions and warnings for safe operation.
Avoid water, ensure ventilation, keep away from heat, protect cord, unplug during storms.
Use specified accessories, refer servicing to qualified personnel, and correct disconnection methods.
Adjusts amplifier's input impedance, overall gain, and high-frequency response.
Controls for adjusting mid-range, low-mid, high frequencies, and bass response.
Adjusts master output level, reverb effect, and high-frequency contour.
Connects AC power, features fuse, power switch, and speaker output jacks.
Connects outboard effects and selects amplifier gain sensitivity and feel.
Controls reverb drive signal and provides location for amplifier's serial number.
Details fuse types and ratings for different voltage exports (100V, 120V, 220-240V).
Lists vacuum tubes used in the amplifier and their respective functions.
Step-by-step guide for adjusting amplifier bias using a multimeter and screwdriver.
Provides phone, fax, address, service email, and website for Two-Rock.
Advises against moisture, solvents, and recommends professional servicing for repairs.
States compliance with EU directives for Low Voltage and Electromagnetic Compatibility.
Lists EN standards met and period for CE mark affixing, plus manufacturer details.
General| Type | Tube Amplifier |
|---|---|
| Power Output | 35 Watts |
| Reverb | Yes |
| Inputs | 1 x 1/4" |
| Effects Loop | Yes |
| Tubes | 4 x 12AX7, 2 x 6L6 |
| Controls | Treble, Middle, Bass, Reverb |
| Speaker Output | 4 ohm, 8 ohm, 16 ohm |
| Channels | 2 (Clean, Lead) |
| EQ | 3-Band (Bass, Mid, Treble) |
To Next Page
