When you do last step please make the spindle running because the cutter may
touch the object you want to engrave.
After first testing, then you can try to make your own gcode for
engraving.Gcode is the command that make the machine move. It
should be a .nc file. In the folder there are some .nc files. You can check.
Matched software to make .nc file is ARTCAM(In the link it is old
version, if you want to get latest version you can search it on internet, it
is very common software):
https://www.dropbox.com/s/n1pi86z2lu5zd8q/ArtCAM.rar?dl=0 This is
one version, you can also get some other latest version on internet.
You can also watch these videos on Youtube to know how to make .nc
files by using
ARTCAM:https://www.youtube.com/user/delcamartcam/videos
TTC450
Operation Guide
31
To Next Page
Loading...
