801AP
17A-05-AP
2 11/02
© 2002 Tyco Safety Products PAGE 7 of 10
Registered Office: First Floor North Building Walden CourtParsonage Lane Bishopís Stortford Herts CM23 5DB
EQUIPMENT:
PUBLICATION:
ISSUE No. & DATE:
COMMISSION DATE
Selecting COMMISSION DATE from the main menu
displays the date of device commissioning, which is
downloaded from the MX Front Panel (CIE) on the actual
date of commissioning. Press ‘Menu’ to return to main menu.
DEVICE TYPE ID
DEVICE TYPE ID displays the addressable device Model
No. eg, 801PH. Select DEVICE TYPE ID and the detector
type is displayed.
LED MODE
The LED on the attached addressable device can be
programmed to blink, it will flash each time the detector is
polled. This can be done by selecting ‘Blnk’.
• To switch off the blinking select ‘Off’
• Test the LED status by selecting ‘Tst’.
This turns the LED ‘On’ for 2 to 3
seconds
• Press ‘Men’ to return to the main menu
For all devices using the MIM800 module (eg,
call points) or Intrinsically Safe varients (eg,
CP840Ex Callpoint), the LED can not be made
to illuminate unless the device is powered from
the addressable loop. Observe the warning (see
DIGITAL OUTPUTS) when connecting the
Service Tool to a device on the addressable
loop.
DIGITAL INPUTS
This menu option displays the status of the digital inputs as a
decimal number between 0 to 255 for all addressable devices.
For ancillaries RIM800 and APM800, the following status
messages are displayed (in addition to the decimal number):
DIGITAL OUTPUTS
The user may set the Digital Output of the addressable device
by using the following function buttons, F2 to F4:
Flashing cursor denotes the digit to be set.
• - moves the cursor one position to the
right
• Tog - toggles between 0 and 1 for each digit
• ‘Set’ - prompts the 801AP to send an
instruction to the addressable device
• ‘Menu’ - to return to the main menu options
WARNING:
WHEN USING THE SERVICE TOOL WITH AN
ANCILLARY DEVICE CONNECTED TO THE
ADDRESSABLE LOOP, MAKE SAFE ANY
ATTACHED EQUIPMENT, eg, EXTINGUISHING,
PLANT SHUTDOWN etc. UNLESS IT IS BEING
USED SPECIFICALLY FOR TESTING THE
ATTACHED EQUIPMENT.
RIM800 APM800
Relay Activ Device OK
Relay Inact Device Flt
Relay Fault
To Next Page
Loading...
