Tyco DigiTrace 920 Series

To Next Page

To Previous Page

Current Turns Ratio 1.00 to 1

Autocycle Enable

Autocycle Interval 8

Autocycle Units Hours

Inhibit Ctl Disable

Load Shedding Disable

Configuration Mode Main Menu

Parameter Factory User

Control Setpoint 68°F (20°C)

TS Alarms Configuration Sub-Menu

Parameter Factory User

TS 1 Fail Enable

Lo TS 1 Alarm Enable

Lo TS 1 14°F (–10°C)

Hi TS 1 Alarm Enable

Hi TS 1 212°F (100°C)

TS 2 Fail Disable

Lo TS 2 Alarm Disable

Lo TS 2 —

Hi TS 2 Alarm Disable

Hi TS 2 —

Latch TS Alarms Yes

TS CTL Fail Alarm Enable

Point Setup Sub-Menu (Continued)

Tyco DigiTrace 920 Series - Page 78