Tyco iSTAR Ultra G2 User Manual

Overview
The iSTAR Ultra G2 is a network-ready door controller supporting hard-wired and wireless locks. It consists of the
following hardware components:
■ 1 General Controller Module (GCM),
■ Up to 4 Access Control Modules (ACM), or up to 32 IP-ACM Ethernet Door Modules.
The iSTAR Ultra G2 is supported on C•CURE 9000 v2.90 SP2, and later, with firmware version 6.8.5 and higher.
The iSTAR Ultra G2 is supported on C•CURE 9000 v2.70, and later, for Ultra mode only.
General Controller Module
The General Controller Module (GCM) is a general purpose module which operates using a Linux operating system.
Access Control Module
The Access Control Module (ACM) is a special purpose module that provides inputs, outputs, reader interfaces, and AUX
outputs for the GCM.
IP-ACM Ethernet Door Module
The IP-ACM module provides connection and management of access control for 2 readers.
NOTE
• All controllers and networking equipment in a cluster must be UL listed to qualify as UL Listed Products.
• USB has not been evaluated by UL.
2

Tyco iSTAR Ultra G2 Specifications

General

Brand	Tyco
Model	iSTAR Ultra G2
Category	Controller
Language	English