D-307164 MP-902 PG2 Installation instructions 1
1. Overview
The MP-902 PG2 is a smart, wireless outdoor curtain PIR detector with
anti-masking. It is supported by the PowerMaster alarm system and uses
PowerG two-way communication protocol.
The detector has the following features:
l
l
l
l
l
l
l
l
l
l
l
l
l
l
Two channel Pyro (patented) thermal sensor output
Microprocessor-controlled temperature compensation
White light protection
Adjustable pet immunity selector with three options: no pet, a small pet
weighing less than 3 kg or 6.6 lb, or a pet weighing less than 18 kg
or 40 lb.
Adjustable detection sensitivity
Parabolic and elliptical optics (patented)
Target Specific Imaging™ (TSI) technology distinguishes between
humans and pets weighing up to 18 kg or 40 lbs
True Motion Recognition™ algorithm (patented) distinguishes
between the true motion of an intruder and any other disturbances
which may cause false alarms.
Cross-direction detection: both directions, left to right, and right to left.
Active smart anti-masking ability recognizes spray and dust (patented)
No vertical adjustment is needed.
Long-life battery which is due to the ultralow current consumption
Front and back tamper protection (patented)
Supports temperature and light level reports according to the PowerG
panel version
Note:For UL installations, only use the device with UL listed control units.
Figure 1: MP-902 PG2
1. Bracket
2. Detector
3. Indication LED
4. PIR optical window
2. Installation advice
Qualified service persons only can install the MP-902 PG2. Before you install the device, consider the following points:
l Install the MP-902 PG2 according to the Standard for Installation and
Classification of Burglar and Holdup Alarm Systems, UL 681.
l Mount the detector so that the expected movement of the intruder will
cross the PIR beam.
l Mount the device on a vertical surface and as straight as possible.
l Mount the device upright. See Figure 2.
l Direct the detector at a stable surface, such as a wall or fence, to
provide a curtain detection boundary for better detection.
l Mount the device at a height that agrees with your pet immunity
preference. See Setting the pet immunity for more information.
l Consider weather conditions that can trigger false alarms, such as
moving tree branches or leaves, and other related environmental
conditions
l Locate the device at least 20 cm from all persons during normal
operation to comply with FCC and ISED Canada RF exposure
compliance requirements
l Install the device over sloped ground. See Figure 3.
l Install the device close to tree branches as weather conditions can
cause movement, resulting in false alarms
l Install the device in hazardous locations
l Install the device in areas with a pollution degree higher than pollution
degree 2
l Install the device in circuits above overvoltages category II
l Obscure the field of view of the detector
l Co-locate or operate the antennas used for this product in conjunction
with any other antenna or transmitter
l Mount the device on surfaces where surface vibration can occur
Figure 2:
Mounting orientation
Figure 3: Flat ground installation
MP-902 PG2
Wireless outdoor curtain PIR detector with anti-masking and pet immunity
Installation instructions
Do:
Do
not:
To Next Page
Need help?
General
