T1200
MARINEC-P-A
3 02/14
PAGE 62 of 67
22. Appendix
22.1 EN54 Optional Functions with
Requirements
The T1200-C
panel has the following EN54 optional
functions:
• Clause 7.8 Outputs to fire alarm devices.
• Clause 7.9 Outputs to fire alarm routing
equipment.
• Clause 7.10 Outputs to Fire Protection
Equipment.
• Clause 8.4 Total loss of the power supply.
• Clause 8.9 Output to fault warning routing
equipment.
• Clause 10 Test condition.
22.2 Ancillary Functions Not Required
By EN54
The T1200
panel offers several auxiliary functions
that are not required/allowed by EN54. These are:
• Fire [Routing], Fire Protection and Fault
[Routing] outputs can be configured to be volt-
free change over contacts.
• Detection zones can be configured as non-
latching.
• Detection zones can be configured for
Intrinsically Safe applications.
• Class change input - operates sounders briefly
to signal class changes in educational
institutions. [Land-based feature].
• Reset relay to interrupt power supplies to
external equipment that needs to be reset in
tandem with the T1200-C panel (e.g. IR Beam
Detectors).
• Engineer configurable features:
o To require the silencing of the fire alarm
condition prior to enabling the fire alarm
condition reset.
o To inhibit the operation of the Fire
Protection Output for a fire condition on a
zone configured as non-latching.
o To inhibit the silencing of fire alarm
devices and resetting of the fire alarm
condition for a period of 3 minutes after a
fire alarm condition occurs.
o To prevent fire alarm devices operating
for any fire alarm condition other than the
Manual Fire Alarm/Muster condition.
o To disable the panel buzzer.
• Open collector outputs for Manual Fire
Alarm/Muster active, buzzer active,
disablement active, zonal fire O/Ps for each
zone up to zone 4.
• Remote inputs for remote Manual Fire
Alarm/Muster, remote reset and remote silence
alarms.
• One Man Sounder Test [see 16.6].
• Latching fault mode where all fault conditions
latch until the panel is manually reset.
• Restore default configuration of zones and
outputs.
• Selectable options for operation in the Manual
Fire Alarm or Muster modes.
• Muster alarm capable of being initiated, locally
or from a repeater panel, even if panel
processors fail.
• Dimmable LEDs on the display.
To Next Page
Loading...
Need help?
General
